User Guide
Table Of Contents
- Notices
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- 2.1 Chassis cover
- 2.2 CPU installation
- 2.3 CPU heatsink and fan assembly installation
- 2.4 System memory
- 2.5 Assembly module
- 2.6 5.25-inch drive
- 2.7 Card reader
- 2.8 Hard disk drives (HDD)
- 2.9 Expansion slots
- 2.10 System fan
- 2.11 BIOS update utility
- 2.12 Motherboard rear and audio connection
- 2.13 Starting up for the first time
- 2.14 Turning off the computer
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- Chapter 5: RAID Configuration
- Appendix
Chapter 2: Hardware Setup
2-10
4. Connect the SATA cable to the
SATA connector of the drive.
5. Connect a SATA power cable from
the power supply to the power
connector of the drive.
6. Reinstalltheassemblymoduleand
front panel cover. Refer to 2.5.2
Replacing the assembly module and
front cover for more information.
2.6 5.25-inch drive
To install a 5.25-inch drive to the assembly module:
1. Remove the assembly module from
the chassis. Refer to 2.5.1 Removing
the assembly module for more
information.
2. Insert and carefully push the drive
into the bay until its screw holes align
with the holes on the bay.
3. Secure the 5.25-inch drive with two
(2) screws into the screw holes on
the left side of the assembly module.
Screw holes