User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 AMD CBS
- 4.5.3 Onboard LAN Configuration
- 4.5.4 Serial Port Console Redirection
- 4.5.5 CPU Configuration
- 4.5.6 PCI Subsystem Settings
- 4.5.7 USB Configuration
- 4.5.8 Network Stack Configuration
- 4.5.9 NVMe Configuration
- 4.5.10 SATA Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Driver Health
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
Chapter 2: Hardware Setup
2-16
4. Push the storage device and drive tray assembly all the way into the the drive bay until
the tray lever and spring lock clicks and secures the drive tray in place.
5. Repeat steps 1 to 4 to install additional 2.5” storage devices.
To install 2.5-inch storage devices into storage bays 3, 4, 5, and 6:
1. Remove the drive tray.
Refer to the
Installing a 3.5-inch SATA/SAS storage device
section for the steps on
removing the drive tray.
2. Prepare the 2.5-inch storage device and
the bundled set of screws.
3. Place the 2.5-inch storage device into
the tray, then secure it with four screws.
The tool-less notch may interfere when
trying to align the screw holes. Press
the storage device against the notch if
you are experiencing issues trying to
align the screw holes.
4. Insert the tool-less 2.5-inch tray into the
device tray until it clicks in place.
5. Push the storage device and drive tray assembly all the way into the the drive bay until
the tray lever and spring lock clicks and secures the drive tray in place.
6. Repeat steps 1 to 5 to install additional 2.5” storage devices.