User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 AMD CBS
- 4.5.3 Onboard LAN Configuration
- 4.5.4 Serial Port Console Redirection
- 4.5.5 CPU Configuration
- 4.5.6 PCI Subsystem Settings
- 4.5.7 USB Configuration
- 4.5.8 Network Stack Configuration
- 4.5.9 NVMe Configuration
- 4.5.10 SATA Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Driver Health
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
2-9
ASUS ESC4000A-E12
2.2.2 Installing the CPU and liquid cooling module
1. Refer to steps 1 to 8 in the previous section to install the CPU.
2. Remove the screw securing the PCIe riser card to the chassis.
3. Firmly hold the riser card, then pull it up to detach it from the PCIe slot on the
motherboard.
4. Align and place the liquid cooling module assembly in the correct orientation as shown
in the illustration below, then secure the PCIe riser card with the screw you removed
earlier.
5. Connect the leak detection sensor cable to
LIQUID_CONN1
on the motherboard.