User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 AMD CBS
- 4.5.3 Onboard LAN Configuration
- 4.5.4 Serial Port Console Redirection
- 4.5.5 CPU Configuration
- 4.5.6 PCI Subsystem Settings
- 4.5.7 USB Configuration
- 4.5.8 Network Stack Configuration
- 4.5.9 NVMe Configuration
- 4.5.10 SATA Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Driver Health
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
4-15
ASUS ESC4000A-E12
SEV-SNP Support [Disabled]
Configuration options: [Disabled] [Enabled] [Auto]
Allow Compliance [Auto]
Allows you to enable or disable PCIe RP entering the polling compliance state.
SRIS [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Multi Upstream Auto Speed Change [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Multi Auto Speed Change on Last Rate [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
PCIe Link Speed [Auto]
Configuration options: [Maximum speed] [Gen1] [Gen2] [Gen3] [Gen4] [Gen5] [Auto]
FCH Common Options
I3C/I2C Configuration Options
Allows you to configure I3C/I2C options.
SATA Configuration Options
Allows you to configure SATA options.
USB Configuration Options
Allows you to configure USB options.
AC Power Loss Options
Allows you to configure AC power loss options.
UART Configuration Options
Allows you to configure UART options.
ESPI Configuration Options
Allows you to configure ESPI options.
FCH RAS Options
Allows you to configure FCH RAS options.
Miscellaneous Options
Allows you to configure miscellaneous FCH options.
NTB Common Options
Socket-0 P0 NTB Enable [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Socket-0 P2 NTB Enable [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Socket-0 G0 NTB Enable [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Socket-0 G2 NTB Enable [Auto]
Configuration options: [Disabled] [Enabled] [Auto]