User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 AMD CBS
- 4.5.3 Onboard LAN Configuration
- 4.5.4 Serial Port Console Redirection
- 4.5.5 CPU Configuration
- 4.5.6 PCI Subsystem Settings
- 4.5.7 USB Configuration
- 4.5.8 Network Stack Configuration
- 4.5.9 NVMe Configuration
- 4.5.10 SATA Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Driver Health
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
Chapter 2: Hardware Setup
2-8
11. Reinstall the air ducts. For more information, refer to the
Air ducts
section.
9. Place the heatsink on the CPU socket and make sure the heatsink screws are aligned
with the CPU socket.
10. The below instructions must be followed when securing the heatsink to the
motherboard. The order in which the screws should be tightened is shown both in the
illustration below and on the heatsink.
A. Tighten screw just enough to attach the heatsink to the motherboard.
B. Fully tighten screw , then fully tighten screw .
C. Fully tighten the remaining screws in order from to
The heatsink screws are T20 models. A torque value of 12.5±2.5kg-cm (11.0±2.1 lbf-in) is
recommended.