User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 AMD CBS
- 4.5.3 Onboard LAN Configuration
- 4.5.4 Serial Port Console Redirection
- 4.5.5 CPU Configuration
- 4.5.6 PCI Subsystem Settings
- 4.5.7 USB Configuration
- 4.5.8 Network Stack Configuration
- 4.5.9 NVMe Configuration
- 4.5.10 SATA Configuration
- 4.5.11 APM Configuration
- 4.5.12 AMD Mem Configuration Status
- 4.5.13 T1s Auth
- 4.5.14 Driver Health
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
4-14
Chapter 4: BIOS Setup
NBIO Common Options
IOMMU [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
DMAr Support [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
DRTM Virtual Device Support [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
DRTM Memory Reservation [Auto]
Allows you to enable or disable reservation of 128MB memory below Bottom IO for
DRTM. This option is required for Secured-Core Server functionality.
Configuration options: [Disabled] [Enabled] [Auto]
ACS Enable [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
PCIe Alternative Routing ID (ARI) Support [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
PCIe ARI Enumeration [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
PCIe Ten Bit Tag Support [Auto]
Allows you to enable PCIe ten bit tags for supported devices. Support is disabled if this
option is enabled.
Configuration options: [Disabled] [Enabled] [Auto]
SMU Common Options
Allows you to configure SMU Common options.
NBIO RAS Common Options
Allows you to configure NBIO RAS Common options.
Enable AER Cap [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Early Link Speed [Auto]
Configuration options: [Gen1] [Gen2] [Auto]
Hot Plug Handling Mode [Auto]
Configuration options: [OS First] [Firmware First] [System Firmware Intermediary] [Auto]
Presence Detect Select Mode [Auto]
Configuration options: [OR] [AND] [Auto]
Data Link Feature Cap [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
CV Test [Auto]
Allows you to enable or disable support for PCIECV tool. Hardware defaults are
preserved if this option is set to Auto.
Configuration options: [Disabled] [Enabled] [Auto]