User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 PSP Firmware Versions
- 4.5.3 APM Configuration
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 CSM Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 SATA Configuration
- 4.5.13 AMD Mem Configuration Status
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
2-37
ASUS ESC4000A-E11
5. Install the air duct, if supported by the GPU card, and connect the GPU power cable.
The GPU air duct is designed and recommended for dual-slot GPU cards with a length of
10.5 inches.
For GPU card installation with an air duct
Pass the power cable through the air duct and
connect it to the GPU card, then secure the air
duct to the GPU card with two screws.
For GPU card installation without an air duct
Connect the power cable to the GPU.
6. Place the GPU bracket on a flat and stable surface.
7. Remove the screws on the metal covers, then remove the metal covers.
Standard chassis screw (A)
GPU bracket opening
8. Insert the GPU cables into the opening on the GPU bracket.