User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 PSP Firmware Versions
- 4.5.3 APM Configuration
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 CSM Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 SATA Configuration
- 4.5.13 AMD Mem Configuration Status
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
Chapter 2: Hardware Setup
2-34
2.8.4 U.2 drives
1
2
Storage device bay 3 and 4
To install a U.2 drive:
1. Install the U.2 drive to storage device bay 3 or 4.
Refer to the
Installing the 2.5-inch SSD
section for the steps on installing a 2.5-inch drive
to the HDD bay.
2. Remove the slimline SAS cables from the internal SAS/HBA/Storage bracket.
Additional U.2 drives may be installed in storage device bays 3 and 4 as shown in the
illustration below: