User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 PSP Firmware Versions
- 4.5.3 APM Configuration
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 CSM Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 SATA Configuration
- 4.5.13 AMD Mem Configuration Status
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
Chapter 2: Hardware Setup
2-12
1. Remove the drive tray.
Refer to the
Installing the 3.5-inch SATA HDD/SAS HDD
section for the steps on
removing the drive tray.
4. Replace the drive tray.
Refer to the
Installing the 3.5-inch SATA HDD/SAS HDD
section for the steps on
replacing the drive tray.
2. Prepare the SSD/SATA HDD/SAS HDD/
NVMe and the bundled set of screws.
3. Place the SSD/SATA HDD/SAS HDD/
NVMe into the tray (A) then secure it
with four screws (B).
Ensure to take note of the tool-less
notch as it may interfere when trying to
align the screw holes. Press the SSD/
SATA HDD/SAS HDD/NVMe down
on the notch if you are experiencing
issues trying to align the screw holes.
2.4.2 Installing the 2.5-inch SSD/SATA HDD/SAS HDD/NVMe
1
2
Storage device bay 1 and 2
(default NVMe)
Storage device bay 3 and 4
The NVMe drives may be installed in storage device bays 1, 2, 3, and 4 as shown in the
illustration below:
• The default storage device bays to install NVMe drives are storage device bays 1 and 2.
• Support for NVMe drives for storage device bays 3 and 4 is optional, please refer to
the
U.2 drives (optional)
section before installing a NVMe drive to storage device
bays 3 and 4.
5. Repeat steps 1 to 4 to install additional SSD/SATA HDD/SAS HDD/NVMe.