User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Infomation
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 PSP Firmware Versions
- 4.5.3 APM Configuration
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 CSM Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 SATA Configuration
- 4.5.13 AMD Mem Configuration Status
- 4.5.14 iSCSI Configuration
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Save & Exit menu
- 4.11 AMD CBS menu
- 4.12 Event Logs menu
- 4.13 Server Mgmt menu
- Chapter 5: Driver Installation
- Appendix
Chapter 2: Hardware Setup
2-36
2.8.5 GPU cards
Follow the steps below to install a GPU card to the system.
1. Locate and remove the two screws at the rear of the chassis.
2. Locate and loosen the thumbscrew at the front of the GPU bracket.
3. Firmly hold and pull the GPU bracket upwards to detach it from the motherboard.
1
2
1
2
1
2
4. Prepare the appropriate GPU power cable depending on the type of GPU card.
Tesla/AMD
8pin to 6pin power cable
Quadro
8pin to 2x6pin power cable
12VHPWR
12+4pin to 2x6pin power cable