User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: Motherboard Infomation
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Performance Tuning menu
- 5.5 Advanced menu
- 5.5.1 Trusted Computing
- 5.5.2 PSP Firmware Versions
- 5.5.3 APM Configuration
- 5.5.4 Onboard LAN Configuration
- 5.5.5 Serial Port Console Redirection
- 5.5.6 CPU Configuration
- 5.5.7 PCI Subsystem Settings
- 5.5.8 USB Configuration
- 5.5.9 Network Stack Configuration
- 5.5.10 CSM Configuration
- 5.5.11 NVMe Configuration
- 5.5.12 SATA Configuration
- 5.5.13 AMD Mem Configuration Status
- 5.5.14 iSCSI Configuration
- 5.6 Chipset menu
- 5.7 Security menu
- 5.8 Boot menu
- 5.9 Tool menu
- 5.10 Save & Exit menu
- 5.11 AMD CBS menu
- 5.12 Event Logs menu
- 5.13 Server Mgmt menu
- Chapter 6: Driver Installation
- Appendix
5-49
ASUS ESC4000A-E10
The following item appears only when
IPV6 Support
is set to
[Enabled]
.
Configuration Address source [Previous State]
This item allows you to configure LAN channel parameters statistically or dynamically (by
BIOS or BMC). Unspecified option will not modify any BMC network parameters during
BIOS phase.
Configuration options: [Previous State] [Static] [DynamicBmcDhcp]
Shared LAN
IPV6 Support [Enabled]
Allows you to enable or disable LAN2 IPV6 Support.
Configuration options: [Disabled] [Enabled]
The following items appear only when
IPV6 Support
is set to
[Enabled]
.
Configuration Address source [Previous State]
This item allows you to configure LAN channel parameters statistically or dynamically (by
BIOS or BMC). Unspecified option will not modify any BMC network parameters during
BIOS phase.
Configuration options: [Previous State] [Static] [DynamicBmcDhcp]
View System Event Log
This item allows you to view the system event log records.
BMC User Settings
The sub-items in this configuration allow you to add, delete, or change BMC user settings.
BMC Warm Reset
Press <Enter> to perform a BMC Warm Reset.