User Manual

5-42
Chapter 5: BIOS Setup
Diagnostic Mode [Auto]
This item allows you to enable or disable Diag mode.
Configuration options: [Disabled] [Enabled] [Auto]
DLWM Support [Auto]
This item allows you to enable or disable DLWM support.
Configuration options: [Disabled] [Enabled] [Auto]
BoostFmaxEn [Auto]
[Auto] Use the default Fmax.
[Manual] User can set the boost Fmax.
The following item appears only when
BoostFmaxEn
is set to
[Manual]
.
BoostFmax [0]
This item allows you to specify the boost Fmax frequency limit to apply to all cores
(MHz).
NBIO RAS Common Options
NBIO RAS Global Control [Auto]
Configuration options: [Auto] [Manual]
NBIO RAS Control [MCA]
Configuration options: [Disabled] [MCA] [Legacy]
Egress Poison Severity High [30011]
Each bit set to 1 enables HIGH severity on the associated IOHC egress port. A bit of 0
indicates LOW severity.
Egress Poison Severity Low [4]
Each bit set to 1 enables HIGH severity on the associated IOHC egress port. A bit of 0
indicates LOW severity.
NBIO SyncFlood Generation [Auto]
This value may be used to mask SyncFlood caused by NBIO RAS options. When set
to TRUE, SyncFlood from NBIO is masked. When set to FALSE, NBIO is capable of
generating SyncFlood.
Configuration options: [Disabled] [Enabled] [Auto]
NBIO SyncFlood Reporting [Disabled]
This value may be used to enable SyncFlood reporting to APML. When set to TRUE,
SyncFlood will be reported to APML. When set to FALSE, the reporting will be
disabled.
Configuration options: [Disabled] [Enabled]
Egress Poison Mask High [fffcffff]
These set the enable mask for masking of errors logged in EGRESS_POISON_
STATUS. For each bit set to 1, errors are masked. For each bit set to 0, errors trigger
response actions.
Egress Poison Mask Low [fffffffb]
These set the enable mask for masking of errors logged in EGRESS_POISON_
STATUS. For each bit set to 1, errors are masked. For each bit set to 0, errors trigger
response actions.