User Manual

5-36
Chapter 5: BIOS Setup
CsOdtSetup [0]
This item allows you to setup time on CAD bus signals.
Configuration options: [0] - [39]
CkeSetup [0]
This item allows you to setup time on CAD bus signals.
Configuration options: [0] - [39]
CAD Bus Drive Strength User Controls [Auto]
This item allows you to set the CAD bus signals to Auto or Manual.
Configuration options: [Auto] [Manual]
The following items appear only when
CAD Bus Drive Strength User Controls
is set to
[Manual]
.
ClkDrvStren [Auto]
Configuration options: [Auto] [120.0 Ohm] [60.0 Ohm] [40.0 Ohm] [30.0
Ohm] [24.0 Ohm] [20.0 Ohm]
AddrCmdDrvStren [Auto]
Configuration options: [Auto] [120.0 Ohm] [60.0 Ohm] [40.0 Ohm] [30.0
Ohm] [24.0 Ohm] [20.0 Ohm]
Cs0dtDrvStren [Auto]
Configuration options: [Auto] [120.0 Ohm] [60.0 Ohm] [40.0 Ohm] [30.0
Ohm] [24.0 Ohm] [20.0 Ohm]
CkeDrvStren [Auto]
Configuration options: [Auto] [120.0 Ohm] [60.0 Ohm] [40.0 Ohm] [30.0
Ohm] [24.0 Ohm] [20.0 Ohm]
Data Bus Configuration
Data Bus Configuration User Controls [Auto]
This item allows you to specify the mode for drive strength.
Configuration options: [Auto] [Manual]
The following items appear only when
Data Bus Configuration User Controls
is set to
[Manual]
.
RttNom [Auto]
Configuration options: [Rtt_Nom Disable] [RZQ/4] [RZQ/2] [RZQ/6] [RZQ/1]
[RZQ/5] [RZQ/3] [RZQ/7] [Auto]
RttWr [Auto]
Configuration options: [Dynamic ODT Off] [RZQ/2] [RZQ/1] [Hi-Z] [RZQ/3]
[Auto]
RttPark [Auto]
Configuration options: [Rtt_PARK Disable] [RZQ/4] [RZQ/2] [RZQ/6]
[RZQ/1] [RZQ/5] [RZQ/3] [RZQ/7] [Auto]
Common RAS
Data Poisoning [Auto]
Configuration options: [Enabled] [Disabled] [Auto]
DRAM Post Package Repair [Disable]
This item allows you to enable or disable DRAM POST Package Repair.
Configuration options: [Enable] [Disable]