User Manual

2-51
ASUS ESC4000 G4 Series
1
2
2.8.4 Installing Accelerators
Follow the steps below to install the optional accelerator to the system.
1. Locate and remove the two screws at
the rear of the chassis.
2. Locate and loosen the thumbscrew in front of the accelerator bracket.
3. Firmly hold the bracket then pull it up to detach it from the motherboard then set it
aside.
4. Prepare the GPU air duct and the accelerator.
For AMD S9150 or later GPU cards, attach a mylar to the GPU air duct rst before installing
the air duct to the GPU card. To do this, get a mylar (A) then attach it to the air duct (B) as
shown.
The mylar is bundled with the system and included in the accessory box.
mylar
GPU air duct
mylar
1
2