User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Performance Tuning menu
- 5.5 Advanced menu
- 5.5.1 Trusted Computing
- 5.5.2 ACPI Settings
- 5.5.3 Smart Settings
- 5.5.4 Super IO Configuration
- 5.5.5 Serial Port Console Redirection
- 5.5.6 Onboard LAN Configuration
- 5.5.7 APM
- 5.5.8 PCI Subsystem Settings
- 5.5.9 USB Configuration
- 5.5.10 CSM Configuration
- 5.5.11 NVMe Configuration
- 5.5.12 Network Stack Configuration
- 5.5.13 iSCSI Configuration
- 5.6 Platform Configuration menu
- 5.7 Socket Configuration menu
- 5.8 Event Logs menu
- 5.9 Server Mgmt menu
- 5.10 Security menu
- 5.11 Boot menu
- 5.12 Tool menu
- 5.13 Save & Exit menu
- Chapter 6: RAID Configuration
- Chapter 7: Driver Installation
- 7.1 RAID driver installation
- 7.2 Management applications and utilities installation
- 7.3 Running the Support DVD
- 7.4 Intel® chipset device software installation
- 7.5 Installing the Intel® I210 Gigabit Adapters driver
- 7.6 VGA driver installation
- 7.7 Intel® Rapid Storage Technology enterprise 5.0 installation
- Appendix
Chapter 2: Hardware Setup
2-20
ESC4000 G4X
1. Remove the storage device cage.
Refer to section ESC4000 G4X under 2.4.1 Installing the 3.5-inch SATA/SAS storage
device for the steps on removing the storage device cage.
2. Prepare the SATA/SAS/NVME storage
device and the bundled set of screws.
3. Place the SATA/SAS/NVME storage
device into the storage device cage (A),
then secure it using four (4) screws (B).
4. Connect the SATA and power cable to
your SATA/SAS/NVME storage device.
OR
(optional) Connect the NVME cable to
your NVME device.
(optional)
OR
The NVME cable is optional, for more
information about the optional NVME
cable, please visit www.asus.com/
support.
6. Repeat steps 1 to 6 to install the other SATA/SAS/NVME storage device.
5. Replace the storage device cage.
Refer to section ESC4000 G4X under 2.4.1 Installing the 3.5-inch SATA/SAS storage
device for the steps on replacing the storage device cage.