User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Performance Tuning menu
- 5.5 Advanced menu
- 5.5.1 Trusted Computing
- 5.5.2 ACPI Settings
- 5.5.3 Smart Settings
- 5.5.4 Super IO Configuration
- 5.5.5 Serial Port Console Redirection
- 5.5.6 Onboard LAN Configuration
- 5.5.7 APM
- 5.5.8 PCI Subsystem Settings
- 5.5.9 USB Configuration
- 5.5.10 CSM Configuration
- 5.5.11 NVMe Configuration
- 5.5.12 Network Stack Configuration
- 5.5.13 iSCSI Configuration
- 5.6 Platform Configuration menu
- 5.7 Socket Configuration menu
- 5.8 Event Logs menu
- 5.9 Server Mgmt menu
- 5.10 Security menu
- 5.11 Boot menu
- 5.12 Tool menu
- 5.13 Save & Exit menu
- Chapter 6: RAID Configuration
- Chapter 7: Driver Installation
- 7.1 RAID driver installation
- 7.2 Management applications and utilities installation
- 7.3 Running the Support DVD
- 7.4 Intel® chipset device software installation
- 7.5 Installing the Intel® I210 Gigabit Adapters driver
- 7.6 VGA driver installation
- 7.7 Intel® Rapid Storage Technology enterprise 5.0 installation
- Appendix
2-19
ASUS ESC4000 G4 Series
1. Remove the drive tray.
Refer to section ESC4000 G4 under 2.4.1 Installing the 3.5-inch SATA/SAS storage
device for the steps on removing the drive tray.
4. Replace the drive tray.
Refer to section ESC4000 G4 under 2.4.1 Installing the 3.5-inch SATA/SAS storage
device for the steps on replacing the drive tray.
2. Prepare the SATA/SAS/NVME storage
device and the bundled set of screws.
3. Place the SATA/SAS/NVME storage
device into the tray (A) then secure it
with four screws (B).
2.4.2 Installing the 2.5-inch SATA/SAS/NVME storage
device
ESC4000 G4
1
2
Storage device bay 7 and 8
For the ESC4000 G4, the NVME storage devices may be installed in storage device bay 7
and 8 as shown in the illustration below:
5. Repeat steps 1 to 4 to install the other SATA/SAS/NVME storage device.