User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Performance Tuning menu
- 5.5 Advanced menu
- 5.5.1 Trusted Computing
- 5.5.2 ACPI Settings
- 5.5.3 Smart Settings
- 5.5.4 Super IO Configuration
- 5.5.5 Serial Port Console Redirection
- 5.5.6 Onboard LAN Configuration
- 5.5.7 APM
- 5.5.8 PCI Subsystem Settings
- 5.5.9 USB Configuration
- 5.5.10 CSM Configuration
- 5.5.11 NVMe Configuration
- 5.5.12 Network Stack Configuration
- 5.5.13 iSCSI Configuration
- 5.6 Platform Configuration menu
- 5.7 Socket Configuration menu
- 5.8 Event Logs menu
- 5.9 Server Mgmt menu
- 5.10 Security menu
- 5.11 Boot menu
- 5.12 Tool menu
- 5.13 Save & Exit menu
- Chapter 6: RAID Configuration
- Chapter 7: Driver Installation
- 7.1 RAID driver installation
- 7.2 Management applications and utilities installation
- 7.3 Running the Support DVD
- 7.4 Intel® chipset device software installation
- 7.5 Installing the Intel® I210 Gigabit Adapters driver
- 7.6 VGA driver installation
- 7.7 Intel® Rapid Storage Technology enterprise 5.0 installation
- Appendix
Chapter 2: Hardware Setup
2-16
2.4 Storage devices
The ESC4000 G4 series supports 3.5-inch and 2.5-inch SATA/SAS storage devices, or U.2
drives. For the ESC4000 G4 system, the storage device installed in the drive bay connects to
the motherboard SATA/SAS ports via the SATA/SAS backplane.
1. Press the spring lock.
2. Pull the tray lever outwards to remove
the drive tray.
3. Prepare the SATA/SAS storage device
and the bundled set of screws.
4. Place the SATA/SAS storage device into
the tray then secure it with four screws.
5. Push the drive tray and storage device
assembly all the way into the depth of
the bay until the tray lever and spring
lock clicks and secures the drive tray in
place.
2.4.1 Installing the 3.5-inch SATA/SAS storage device
• When installed, the SATA/SAS connector on the drive connects to the SATA/SAS
interface on the backplane.
• The drive tray is correctly placed when its front edge aligns with the bay edge.
6. Repeat steps 1 to 5 to install the other SATA/SAS storage devices.
ESC4000 G4