User Manual

Chapter 2: Hardware setup
2-24
9. Connect the SATA/SAS cables to the SAS1–8 connectors on the PIKE riser card.
11. If you are to install PIKE 2008 and 2108 cards, ensure the heatsink latch is completely
hooked to the edge of the card slot, and then secure the PIKE card through the screw
hole of the riser card to the card bracket.
10. Align and insert the golden ngers of the PIKE SAS RAID card into the card slot on the
PIKE raiser card. Ensure the card is completely seated on the slot.