Configuration Guide

Chapter 2: Components2-6
1. Remove the screws that secure the riser card bracket.
2. Hold the riser card rmly then pull it upward to detach it from the PCI Express
x16 slot on the motherboard.
3. Remove the SATA/SAS cables from the onboard SATA connectors then
connect them to the SAS1-8 connectors on the PIKE riser card.
4. Connect the SGPIO1 cable from the SGPIO1 connector into the SGPIO2
connector on the riser card.
5. Align and insert the golden ngers of the PIKE RAID SAS card into the card
slot of the riser card. Ensure that the PIKE RAID SAS card is seated rmly
into the slot.
6. Align the golden ngers of the riser card bracket with the PCI Express x16
slot on the motherboard then push it rmly into place. Ensure that the riser
card bracket is aligned with the rear panel.
7. Secure that riser card bracket with the screws that you removed in step 1.
If you are using a PIKE 1078 SAS RAID card, snap the iButton into the
iButton slot on the riser card.
Order P/N
Description
90-S00CS0150T PIKE 2108 8-port SAS 6G card. RAID Kit (H/W RAID 0, 1, 10, 5, 6, 50, 60)
90-S00CS0140T PIKE 2008/IMR 8-port SAS 6G card. RAID Kit (RAID 0, 1, 10, 5, 50)
90-S00CS0130T PIKE2008 8-port SAS 6G card. RAID Kit (RAID 0, 1, 10, 1E)