User Manual

CMA Bracket
● Install in #10-32 rack●
● Remove the chassis from rack●
①②
③④
Loosen shipping screws to pull out chassis.
Pull the disconnect tab forward to remove chassis at the full extension position.
➊
➋➌➍
Remove pins for square and round hole rack. Remove nut on the bracket.
Use #10-32 screw in the accessory bag, then fasten nut on the rack post.
➋
● Accessory for CMA bracket●
Please follow previous steps for installation
and detach process of chassis.
②
①
Ⓓ
Ⓓ
When using CMA, please use the accessory.
It is OK not to use accessory when no CMA requirements.
Ⓕ
Copyright © 2021 King Slide. All Rights Reserved
➊
Ⓒ
Rear bracket
Ⓖ
Front bracket
Ⓘ
➌
④
White
③
➍
Ⓓ
Insert the chassis to complete the installation
5
➊➋
➌
➍➎
➏
Pull the middle rails fully extended in lock position, ensure ball bearing retainer is located at the front of the middle rails.
When hit a stop, please pull/push the blue release tab on the inner rails.
Tighten chassis with shipping screws.
Horizontally insert the chassis into middle-outer rails
.
➏
ⒺM5x9.0L
➊
Blue
➍
Click
➋
➎
➌
Ⓘ
Ⓖ
Ⓒ
Electronic File
R