User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 ACPI Settings
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 Onboard LAN Configuration
- 4.5.5 UEFI Variables Protection
- 4.5.6 Serial Port Console Redirection
- 4.5.7 SIO Configuration
- 4.5.8 PCI Subsystem Settings
- 4.5.9 USB Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 APM Configuration
- 4.5.13 T1s Auth Configuration
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Platform Configuration menu
- 4.7 Socket Configuration menu
- 4.8 Security menu
- 4.9 Boot menu
- 4.10 Tool menu
- 4.11 Event Logs menu
- 4.12 Server Mgmt menu
- 4.13 Save & Exit menu
- Chapter 5: Driver Installation
- Appendix
2-26
To connect a 9560 RAID card in NVME configuration:
a. Disconnect the default MCIO cables connected to
MCIO3
and
MCIO4
on the right
backplane.
VPP_I2C1
BP_TP_BP1
BPPWR4
SGPIO_SW1
BP_NUM_SW1
TRI_DIS1
SLIMSAS1
MCIO3
MCIO1
MCIO4
Right backplane
b. Connect the left SLIMSAS connector (B) on the RAID card to
MCIO3
and
MCIO4
on the left backplane using the bundled cables.
c. Connect the right SLIMSAS connector (C) on the RAID card to
MCIO3
and
MCIO4
on the right backplane using the bundled cables.
VPP_I2C1
BP_TP_BP1
BPPWR4
SGPIO_SW1
BP_NUM_SW1
TRI_DIS1
SLIMSAS1
MCIO3
MCIO1
MCIO4
Left backplane
Right backplane
VPP_I2C1
BP_TP_BP1
BPPWR4
SGPIO_SW1
BP_NUM_SW1
TRI_DIS1
SLIMSAS1
MCIO3
MCIO1
MCIO4