User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 ACPI Settings
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 Onboard LAN Configuration
- 4.5.5 UEFI Variables Protection
- 4.5.6 Serial Port Console Redirection
- 4.5.7 SIO Configuration
- 4.5.8 PCI Subsystem Settings
- 4.5.9 USB Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 APM Configuration
- 4.5.13 T1s Auth Configuration
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Platform Configuration menu
- 4.7 Socket Configuration menu
- 4.8 Security menu
- 4.9 Boot menu
- 4.10 Tool menu
- 4.11 Event Logs menu
- 4.12 Server Mgmt menu
- 4.13 Save & Exit menu
- Chapter 5: Driver Installation
- Appendix
2-14
3. Prepare the 2.5-inch storage device, then insert it into the tool-less 2.5” tray.
4. Insert the tool-less 2.5-inch tray into the drive tray until it clicks in place.
5. Align and insert the 2.5-inch storage device and drive tray assembly into the drive bay.
6. Repeat steps 1 to 5 to install additional 2.5-inch storage devices.
2.4.2 Installing a 2.5-inch storage device.
To install 2.5-inch storage devices into storage bays 1 and 2:
1. Remove the drive tray.
Refer to the
Installing a 3.5-inch storage device
section to remove the drive tray.
2. Push the tool-less 2.5-inch tray through the openings on the bottom of the drive tray.