User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 ACPI Settings
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 Onboard LAN Configuration
- 4.5.5 UEFI Variables Protection
- 4.5.6 Serial Port Console Redirection
- 4.5.7 SIO Configuration
- 4.5.8 PCI Subsystem Settings
- 4.5.9 USB Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 APM Configuration
- 4.5.13 T1s Auth Configuration
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Platform Configuration menu
- 4.7 Socket Configuration menu
- 4.8 Security menu
- 4.9 Boot menu
- 4.10 Tool menu
- 4.11 Event Logs menu
- 4.12 Server Mgmt menu
- 4.13 Save & Exit menu
- Chapter 5: Driver Installation
- Appendix
2-8
2.2.2 Installing the CPU and liquid cooling module
1. Remove the screw securing the PCIe riser card to the chassis.
2. Firmly hold the riser card, then pull it up to detach it from the PCIe slot on the
motherboard.
3. Refer to steps 1 to 5 in the previous section to install the CPU into the liquid cooling
module.
4. Align and place the liquid cooling module assembly in the correct orientation as shown
in the illustration below, then secure the PCIe riser card with the screw you removed
earlier.
5. Refer to steps 7 to 8 in the previous section to secure the liquid cooling module.
6. Connect the leak detection sensor cable to
WL_CON1
on the motherboard.