User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 OffBoard SATA Controller Configuration
- 4.4.2 Trusted Computing
- 4.4.3 ACPI Settings
- 4.4.4 Redfish Host Interface Settings
- 4.4.5 Onboard LAN Configuration
- 4.4.6 Serial Port Console Redirection
- 4.4.7 SIO Common Setting
- 4.4.8 SIO Configuration
- 4.4.9 PCI Subsystem Settings
- 4.4.10 USB Configuration
- 4.4.11 Network Stack Configuration
- 4.4.12 CSM (Compatibility Support Module)
- 4.4.13 NVMe Configuration
- 4.4.14 APM Configuration
- 4.4.15 Third-party UEFI driver configurations
- 4.5 Platform Configuration menu
- 4.6 Socket Configuration menu
- 4.7 Event Logs menu
- 4.8 Server Mgmt menu
- 4.9 Security menu
- 4.10 Boot menu
- 4.11 Tool menu
- 4.12 Save & Exit menu
- Chapter 5: Driver Installation
- Appendix
2-35
ASUS ESC4000-E10
Standard chassis screw (A) #6-32 X L 4.2 OD 6mm 6.0±0.5 kgf-cm
GPU support screw (B) #6-32 X L 4.76 OD 8mm 6.0±0.5 kgf-cm
9. Align and insert the golden fingers of the GPU card into the card slot on the bracket
and ensure that it is securely seated in the slot.
10. Secure the GPU card and air duct assembly to the GPU bracket.
For GPU card installation with an air duct
Secure the GPU card to the GPU bracket with two standard chassis screws, then
secure the air duct using one GPU support screw.
For GPU card installation without an air duct
Secure the GPU card to the GPU bracket with one or two GPU support screws
depending on the type of GPU card.
11. Repeat steps 4 to 10 if you need to install an additional GPU card to the bracket.
GPU support screw (B)
GPU support screw (B)
Standard chassis screw (A)
The GPU support screws are bundled in the accessory bag. Contact your retailer if any
screws are missing.