User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 OffBoard SATA Controller Configuration
- 4.4.2 Trusted Computing
- 4.4.3 ACPI Settings
- 4.4.4 Redfish Host Interface Settings
- 4.4.5 Onboard LAN Configuration
- 4.4.6 Serial Port Console Redirection
- 4.4.7 SIO Common Setting
- 4.4.8 SIO Configuration
- 4.4.9 PCI Subsystem Settings
- 4.4.10 USB Configuration
- 4.4.11 Network Stack Configuration
- 4.4.12 CSM (Compatibility Support Module)
- 4.4.13 NVMe Configuration
- 4.4.14 APM Configuration
- 4.4.15 Third-party UEFI driver configurations
- 4.5 Platform Configuration menu
- 4.6 Socket Configuration menu
- 4.7 Event Logs menu
- 4.8 Server Mgmt menu
- 4.9 Security menu
- 4.10 Boot menu
- 4.11 Tool menu
- 4.12 Save & Exit menu
- Chapter 5: Driver Installation
- Appendix
2-33
ASUS ESC4000-E10
2.8.4 GPU cards
Follow the steps below to install a GPU card to the system.
1. Locate and remove the two screws at the rear of the chassis.
2. Locate and loosen the thumbscrew at the front of the GPU bracket.
3. Firmly hold and pull the GPU bracket upwards to detach it from the motherboard.
1
2
1
2
1
2
4. Prepare the appropriate GPU power cable depending on the type of GPU card.
Tesla/AMD
8pin to 6pin power cable
Quadro
8pin to 2x6pin power cable
12VHPWR
12+4pin to 2x6pin power cable