User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 OffBoard SATA Controller Configuration
- 4.4.2 Trusted Computing
- 4.4.3 ACPI Settings
- 4.4.4 Redfish Host Interface Settings
- 4.4.5 Onboard LAN Configuration
- 4.4.6 Serial Port Console Redirection
- 4.4.7 SIO Common Setting
- 4.4.8 SIO Configuration
- 4.4.9 PCI Subsystem Settings
- 4.4.10 USB Configuration
- 4.4.11 Network Stack Configuration
- 4.4.12 CSM (Compatibility Support Module)
- 4.4.13 NVMe Configuration
- 4.4.14 APM Configuration
- 4.4.15 Third-party UEFI driver configurations
- 4.5 Platform Configuration menu
- 4.6 Socket Configuration menu
- 4.7 Event Logs menu
- 4.8 Server Mgmt menu
- 4.9 Security menu
- 4.10 Boot menu
- 4.11 Tool menu
- 4.12 Save & Exit menu
- Chapter 5: Driver Installation
- Appendix
2-25
ASUS ESC4000-E10
2.5.4 Installing an M.2 (NGFF) card
1. Locate the M.2 connector (NGFF1) on the motherboard.
You may install an M.2 card (supports up to 2280) to the onboard M.2 (NGFF) slot on the
motherboard.
2. Remove the screw on the stand screw.
3. Prepare the M.2 card, then align and insert the M.2 card into the M.2 connector (NGFF1).
4. Secure the M.2 card with the screw you removed in step 2.