User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 OffBoard SATA Controller Configuration
- 4.4.2 Trusted Computing
- 4.4.3 ACPI Settings
- 4.4.4 Redfish Host Interface Settings
- 4.4.5 Onboard LAN Configuration
- 4.4.6 Serial Port Console Redirection
- 4.4.7 SIO Common Setting
- 4.4.8 SIO Configuration
- 4.4.9 PCI Subsystem Settings
- 4.4.10 USB Configuration
- 4.4.11 Network Stack Configuration
- 4.4.12 CSM (Compatibility Support Module)
- 4.4.13 NVMe Configuration
- 4.4.14 APM Configuration
- 4.4.15 Third-party UEFI driver configurations
- 4.5 Platform Configuration menu
- 4.6 Socket Configuration menu
- 4.7 Event Logs menu
- 4.8 Server Mgmt menu
- 4.9 Security menu
- 4.10 Boot menu
- 4.11 Tool menu
- 4.12 Save & Exit menu
- Chapter 5: Driver Installation
- Appendix
Chapter 2: Hardware Setup
2-18
2.5.2 Installing an ASUS PIKE II card
You may install an ASUS PIKE II card to the internal SAS/HBA/Storage bracket located in the
front of the system.
1. Remove the two (2) default slimline SAS cables from the internal SAS/HBA/Storage
bracket.
2. Remove the screw from the bracket (A), then push the internal SAS/HBA/Storage
bracket towards the rear to remove the internal SAS/HBA/Storage bracket (B).