User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Advanced menu
- 5.4.1 OffBoard SATA Controller Configuration
- 5.4.2 Trusted Computing
- 5.4.3 ACPI Settings
- 5.4.4 Redfish Host Interface Settings
- 5.4.5 Onboard LAN Configuration
- 5.4.6 Serial Port Console Redirection
- 5.4.7 SIO Common Setting
- 5.4.8 SIO Configuration
- 5.4.9 PCI Subsystem Settings
- 5.4.10 USB Configuration
- 5.4.11 Network Stack Configuration
- 5.4.12 CSM (Compatibility Support Module)
- 5.4.13 NVMe Configuration
- 5.4.14 APM Configuration
- 5.4.15 Third-party UEFI driver configurations
- 5.5 Platform Configuration menu
- 5.6 Socket Configuration menu
- 5.7 Event Logs menu
- 5.8 Server Mgmt menu
- 5.9 Security menu
- 5.10 Boot menu
- 5.11 Tool menu
- 5.12 Save & Exit menu
- Chapter 6: Driver Installation
- Appendix
Chapter 2: Hardware Setup
2-14
1. Remove the drive tray.
Refer to the
Installing the 3.5-inch SATA HDD/SAS HDD
section for the steps on
removing the drive tray.
4. Replace the drive tray.
Refer to the
Installing the 3.5-inch SATA HDD/SAS HDD
section for the steps on
replacing the drive tray.
2. Prepare the SSD/SATA HDD/SAS HDD/
NVMe and the bundled set of screws.
3. Place the SSD/SATA HDD/SAS HDD/
NVMe into the tray (A) then secure it
with four screws (B).
Ensure to take note of the tool-less
notch as it may interfere when trying to
align the screw holes. Press the SSD/
SATA HDD/SAS HDD/NVMe down
on the notch if you are experiencing
issues trying to align the screw holes.
2.4.2 Installing the 2.5-inch SSD/SATA HDD/SAS HDD/NVMe
1
2
Storage device
bay 1 and 2
(default NVMe)
Storage device
bay 3 and 4
(optional NVMe)
Storage device
bay 5 and 6
(optional NVMe)
Storage device
bay 7 and 8
(optional NVMe)
The NVMe drives may be installed in storage device bays 1 to 8 as shown in the illustration
below:
• The default storage device bays to install NVMe drives are storage device bays 1 and 2.
• Support for NVMe drives for storage device bays 3 to 8 is optional, please refer to
section
Reconnecting the cable for 8 NVMe configuration (only for SKU-3)
before
installing a NVMe drive to storage device bays 3 to 8.
5. Repeat steps 1 to 4 to install additional SSD/SATA HDD/SAS HDD/NVMe.