User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Advanced menu
- 5.4.1 OffBoard SATA Controller Configuration
- 5.4.2 Trusted Computing
- 5.4.3 ACPI Settings
- 5.4.4 Redfish Host Interface Settings
- 5.4.5 Onboard LAN Configuration
- 5.4.6 Serial Port Console Redirection
- 5.4.7 SIO Common Setting
- 5.4.8 SIO Configuration
- 5.4.9 PCI Subsystem Settings
- 5.4.10 USB Configuration
- 5.4.11 Network Stack Configuration
- 5.4.12 CSM (Compatibility Support Module)
- 5.4.13 NVMe Configuration
- 5.4.14 APM Configuration
- 5.4.15 Third-party UEFI driver configurations
- 5.5 Platform Configuration menu
- 5.6 Socket Configuration menu
- 5.7 Event Logs menu
- 5.8 Server Mgmt menu
- 5.9 Security menu
- 5.10 Boot menu
- 5.11 Tool menu
- 5.12 Save & Exit menu
- Chapter 6: Driver Installation
- Appendix
Chapter 2: Hardware Setup
2-8
6. Do two (2) clockwise turns on each of the heatsink screws in the cross order pattern
shown on the illustration until the heatsink screws are tightened and the heatsink is
secured onto the motherboard.
Intel
®
recommends a using a torque driver with a T-30 bit and a torque value of 8 lbf-in to
prolong the longetivity of all PEEK nuts after the quality of the load post is corrected.
7. Reinstall the air duct. For more information, see the section
Air Duct
.