User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Advanced menu
- 5.4.1 OffBoard SATA Controller Configuration
- 5.4.2 Trusted Computing
- 5.4.3 ACPI Settings
- 5.4.4 Redfish Host Interface Settings
- 5.4.5 Onboard LAN Configuration
- 5.4.6 Serial Port Console Redirection
- 5.4.7 SIO Common Setting
- 5.4.8 SIO Configuration
- 5.4.9 PCI Subsystem Settings
- 5.4.10 USB Configuration
- 5.4.11 Network Stack Configuration
- 5.4.12 CSM (Compatibility Support Module)
- 5.4.13 NVMe Configuration
- 5.4.14 APM Configuration
- 5.4.15 Third-party UEFI driver configurations
- 5.5 Platform Configuration menu
- 5.6 Socket Configuration menu
- 5.7 Event Logs menu
- 5.8 Server Mgmt menu
- 5.9 Security menu
- 5.10 Boot menu
- 5.11 Tool menu
- 5.12 Save & Exit menu
- Chapter 6: Driver Installation
- Appendix
5-51
ASUS ESC4000-E10
5.6.5 Advanced Power Management Configuration
Pcode Dispatcher Watchdog Timer [Auto]
Allows you to enable or disable Pcode Dispatcher Watchdog Timer.
Configuration options: [Disable] [Enable] [Auto]
CPU P State Control
P State Control Configuration Sub Menus, including Turbo, XE, etc.
Uncore Freq Scaling [Enable]
If disable, user can input Uncore Frequency.
Configuration options: [Disable] [Enable]
The following item appears only when
Uncore Freq Scaling
is set to
[Disable]
.
Uncore Freq [127]
Configuration options: [0] - [127]
AVX Licence Pre-Grant Override [Disable]
Enabled AVX ICCP pre-grant level override.
Configuration options: [Disable] [Enable]
The following item appears only when
AVX Licence Pre-Grant Override
is set to
[Enable]
.
AVX ICCP pre-grant level [128 Heavy]
Pre-grants an AVX level to the core. Base frequency is not updated.
Configuration options: [128 Heavy] [256 Light] [256 Heavy] [512 Light] [512 Heavy]
SpeedStep (Pstates) [Enable]
Allows you to enable or disable EIST (P-States).
Configuration options: [Disable] [Enable]
The following items appear only when
SpeedStep (Pstates)
is set to
[Enable]
.
Configure TDP Lock [Enable]
Allows you to configure TDP CONTROL Lock Bit.
Configuration options: [Disable] [Enable]