User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 ACPI Settings
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 Onboard LAN Configuration
- 4.5.5 UEFI Variables Protection
- 4.5.6 Serial Port Console Redirection
- 4.5.7 SIO Configuration
- 4.5.8 PCI Subsystem Settings
- 4.5.9 USB Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 APM Configuration
- 4.5.13 T1s Auth Configuration
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Platform Configuration menu
- 4.7 Socket Configuration menu
- 4.8 Security menu
- 4.9 Boot menu
- 4.10 Tool menu
- 4.11 Event Logs menu
- 4.12 Server Mgmt menu
- 4.13 Save & Exit menu
- Chapter 5: RAID Configuration
- Chapter 6: Driver Installation
- Appendix
2-38
2.7.6 Chassis intrusion sensor
A chassis intrusion sensor will come pre-installed on your system and is connected to the
Chassis Intrusion connector (2-pin INTRUSION1) on the midplane. To disable the chassis
intrusion sensor, short the CHASSIS# and GND pins with a jumper cap.
2.8 Rail kit options
This server system supports the rail kit options listed below. For more information on rail kit
installation, refer to corresponding documentation on the ASUS support site or on the official
product site for this server system.
• We strongly recommend that at least two able-bodied persons perform the installation
of the rail kit.
• We recommend the use of an appropriate lifting tool or device, if necessary.
• 2U L-shelf rail kit