User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 ACPI Settings
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 Onboard LAN Configuration
- 4.5.5 UEFI Variables Protection
- 4.5.6 Serial Port Console Redirection
- 4.5.7 SIO Configuration
- 4.5.8 PCI Subsystem Settings
- 4.5.9 USB Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 APM Configuration
- 4.5.13 T1s Auth Configuration
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Platform Configuration menu
- 4.7 Socket Configuration menu
- 4.8 Security menu
- 4.9 Boot menu
- 4.10 Tool menu
- 4.11 Event Logs menu
- 4.12 Server Mgmt menu
- 4.13 Save & Exit menu
- Chapter 5: RAID Configuration
- Chapter 6: Driver Installation
- Appendix
2-20
2.5 Storage devices
The system supports up to ten (10) 2.5-inch NVMe storage devices and up to two (2) 2.5-
inch hot-swap NVMe/SATA(PCH)/SAS storage devices. Storage devices installed on storage
device trays connect to the motherboard via the NVMe/SATA/SAS backplane (SAS storage
devices require an optional HBA/RAID card).
2.5-inch storage bay 1-8 2.5-inch storage bay 9-10
2.5.1 Installing a 2.5-inch storage device
To install a 2.5-inch storage device:
1. Press the spring lock to release the tray lever and partially eject the tray from the bay.
2. Firmly hold the tray lever and pull the storage device tray out of the bay.