User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 ACPI Settings
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 Onboard LAN Configuration
- 4.5.5 UEFI Variables Protection
- 4.5.6 Serial Port Console Redirection
- 4.5.7 SIO Configuration
- 4.5.8 PCI Subsystem Settings
- 4.5.9 USB Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 APM Configuration
- 4.5.13 T1s Auth Configuration
- 4.5.14 Third-party UEFI driver configurations
- 4.6 Platform Configuration menu
- 4.7 Socket Configuration menu
- 4.8 Security menu
- 4.9 Boot menu
- 4.10 Tool menu
- 4.11 Event Logs menu
- 4.12 Server Mgmt menu
- 4.13 Save & Exit menu
- Chapter 5: RAID Configuration
- Chapter 6: Driver Installation
- Appendix
2-14
8. Attach the CPU to the carrier bracket, ensure the triangle mark is on the same side as
the bracket lever, then attach the CPU and carrier bracket to the heatsink.
The CPU carrier differs depending on the type of CPU. Ensure that the CPU carrier
corresponds to the CPU being installed.
9. Align the CPU and heatsink assembly in the correct orientation so that the triangle
marks on both the CPU and socket are aligned in the same direction, then place the
heatsinks on top of the CPU sockets.
The CPU and CPU Carrier fits in only one correct orientation. DO NOT force the CPU and
CPU Carrier into the socket to prevent damaging the CPU pins on the socket.
10. Once the heatsink is placed on top of the CPU socket (A), push the lock latches
outwards on all four corners of the heatsink so that the heatsink and CPU assembly is
secured to the CPU socket (B).
Ensure the triangle mark on the CPU is located in the same corner as the CPU socket.