User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.2 Trusted Computing
- 4.5.2 PSP Firmware Versions
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 AMD CBS
- 4.5.5 APM Configuration
- 5.5.6 Onboard LAN Configuration
- 4.5.7 Serial Port Console Redirection
- 4.5.8 CPU Configuration
- 4.5.9 PCI Subsystem Settings
- 4.5.10 USB Configuration
- 4.5.11 Network Stack Configuration
- 4.5.12 CSM Configuration
- 4.5.13 NVMe Configuration
- 4.5.14 AMD Mem Configuration Status
- 4.5.15 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
4-41
ASUS ESC N4A-E11
The following item appears only when Uart 0 Enable is set to [Enabled].
Uart 0 Legacy Options [Auto]
Configuration options: [Disabled] [0x2E8] [0x2F8] [0x3E8] [0x3F8] [Auto]
Uart 1 Enable [Auto]
Uart 1 has no HW FC is Uart 3 is enabled.
Configuration options: [Disabled] [Enabled] [Auto]
The following item appears only when Uart 1 Enable is set to [Enabled].
Uart 1 Legacy Options [Auto]
Configuration options: [Disabled] [0x2E8] [0x2F8] [0x3E8] [0x3F8] [Auto]
Uart 2 Enable (no HW FC) [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
The following item appears only when Uart 2 Enable (no HW FC) is set to [Enabled].
Uart 2 Legacy Options [Auto]
Configuration options: [Disabled] [0x2E8] [0x2F8] [0x3E8] [0x3F8] [Auto]
Uart 3 Enable (no HW FC) [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
The following item appears only when Uart 3 Enable (no HW FC) is set to [Enabled].
Uart 3 Legacy Options [Auto]
Configuration options: [Disabled] [0x2E8] [0x2F8] [0x3E8] [0x3F8] [Auto]
FCH RAS Options
ALink RAS Support [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
Reset after sync flood [Auto]
Enable AB to forward downstream sync-flood message to system controller.
Configuration options: [Disabled] [Enabled] [Auto]
Miscellaneous Options
Boot Timer Enable [Auto]
[Disabled] Force PMx44 bit 27 = 1.
[Enabled] Force PMx44 bit 27 = 0.
[Auto] PMx44 bit 27 = PcdBootTimerEnable.
NTB Common Options
Socket-0 P0 NTB Enable [Auto]
Allows you to enable NTB on Socket-0 P0 Link.
Configuration options: [Auto] [Enable]