User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Installation Options
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.2 Trusted Computing
- 4.5.2 PSP Firmware Versions
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 AMD CBS
- 4.5.5 APM Configuration
- 5.5.6 Onboard LAN Configuration
- 4.5.7 Serial Port Console Redirection
- 4.5.8 CPU Configuration
- 4.5.9 PCI Subsystem Settings
- 4.5.10 USB Configuration
- 4.5.11 Network Stack Configuration
- 4.5.12 CSM Configuration
- 4.5.13 NVMe Configuration
- 4.5.14 AMD Mem Configuration Status
- 4.5.15 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
4-31
ASUS ESC N4A-E11
ACS Enable [Auto]
AER must be enabled for ACS enable to work.
Configuration options: [Disable] [Enable] [Auto]
PCIe ARI Support [Auto]
This item enables Alternative Routing-ID Interpretation.
Configuration options: [Disable] [Enable] [Auto]
PCIe ARI Enumeration [Auto]
Allows ARI Forwarding for each downstream port.
Configuration options: [Disable] [Enable] [Auto]
PCIe Ten Bit Tag Support [Auto]
This item enables PCIe ten bit tags for supported devices. [Auto] = [Disabled].
Configuration options: [Disable] [Enable] [Auto]
HD Audio Enable [Auto]
Configuration options: [Disabled] [Enable] [Auto]
SMU Common Options
Determinism Control [Manual]
[Auto] Use the fused Determinism.
[Manual] User can set customized Determinism.
The following item appears only when Determinism Control is set to [Manual].
Determinism Slider [Power]
Configuration options: [Auto] [Power] [Performance]
Fan Control
Fan Table Control [Auto]
[Auto] Use the default fan table.
[Manual] User can set customized fan table.
The following item appears only when Fan Table Control is set to [Manual].
Low Temperature [0]
Allows you to set the low temperature in °C.
Medium Temperature [0]
Allows you to set the medium temperature in °C.
High Temperature [0]
Allows you to set the high temperature in °C.
Critical Temperature [0]
Allows you to set the critical temperature in °C.
Low Pwm [0]
Allows you to set the low Pwm from 0-100.
Medium Pwm [0]
Allows you to set the medium Pwm from 0-100.
High Pwm [0]
Allows you to set the high Pwm from 0-100.