User Manual

3-27
華碩 ESC N4A-E11 使用手冊
RttNom [Auto]
設置值有：[Rtt_Nom Disable] [RZQ/4] [RZQ/2] [RZQ/6] [RZQ/1]
[RZQ/5] [RZQ/3] [RZQ/7] [Auto]
RttWr [Auto]
設置值有：[Dynamic ODT Off] [RZQ/2] [RZQ/1] [Hi-Z] [RZQ/3] [Auto]
RttPark [Auto]
設置值有：[Rtt_PARK Disable] [RZQ/4] [RZQ/2] [RZQ/6] [RZQ/1]
[RZQ/5] [RZQ/3] [RZQ/7] [Auto]
以下項目僅當 Data Bus Configuration User Controls 設置為 [Manual]
時才會出現。
Common RAS
Data Poisoning [Auto]
設置值有：[Enabled] [Disabled] [Auto]
DRAM Post Package Repair [Disable]
本項目可以啟用或關閉 DRAM POST Package Repair。設置值有：
[Enable] [Disable]
RCD Parity [Auto]
設置值有：[Enabled] [Disabled] [Auto]
DRAM Address Command Parity Retry [Auto]
設置值有：[Enabled] [Disabled] [Auto]
以下項目僅當 DRAM Address Command Parity Retry 設置為 [Enabled]
時才會出現。
Max Parity Error Replay [8]
十六進位的數值 1、2 或 3 為無效。設置值有：[0] – [39]
Write CRC Enable [Auto]
設置值有：[Enabled] [Disabled] [Auto]
DRAM Write CRC Enable and Retry Limit [Auto]
設置值有：[Enabled] [Disabled] [Auto]
Cs0dtDrvStren [Auto]
設置值有：[Auto] [120.0 Ohm] [60.0 Ohm] [40.0 Ohm] [30.0 Ohm] [24.0
Ohm] [20.0 Ohm]
CkeDrvStren [Auto]
設置值有：[Auto] [120.0 Ohm] [60.0 Ohm] [40.0 Ohm] [30.0 Ohm] [24.0
Ohm] [20.0 Ohm]
Data Bus Configuration
Data Bus Configuration User Controls [Auto]
本項目用來設置驅動強度的模式。設置值有：[Auto] [Manual]