User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: BIOS Setup
- 3.1 Managing and updating your BIOS
- 3.2 BIOS setup program
- 3.3 Main menu
- 3.4 Performance Tuning menu
- 3.5 Advanced menu
- 3.5.1 Trusted Computing
- 3.5.2 PSP Firmware Versions
- 3.5.3 Redfish Host Interface Settings
- 3.5.4 AMD CBS
- 3.5.5 APM Configuration
- 3.5.6 Onboard LAN Configuration
- 3.5.7 Serial Port Console Redirection
- 3.5.8 CPU Configuration
- 3.5.9 PCI Subsystem Settings
- 3.5.10 USB Configuration
- 3.5.11 Network Stack Configuration
- 3.5.12 CSM Configuration
- 3.5.13 NVMe Configuration
- 3.5.14 AMD Mem Configuration Status
- 3.5.15 Third-party UEFI driver configurations
- 3.6 Chipset menu
- 3.7 Security menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Event Logs menu
- 3.11 Server Mgmt menu
- 3.12 Exit menu
- Chapter 4: Driver Installation
- Appendix
3-17
ASUS ESC N4A-E11
The following item appears only when MCA error thresh enable is set to [True].
MCA error thresh count [FF5]
Allows you to set the effective error threshold count = 4095(0xFFF) - <this value> (e.g.
the default value of 0xFF5 results in a threshold of 10).
SMU and PSP Debug Mode [Auto]
When this option is set to [Enabled], specific uncorrected errors detected by the PSP
FW or SMU FW will hang and not reset the system.
Configuration options: [Disabled] [Enabled] [Auto]
Xtrig7 Workaround [Auto]
This workaround is only applicable for Rev A.
[Auto] The bronze workaround is applied.
[No Workaround] Applied for Rev B, and changing the selection for this option
will not result in any changes.
[Bronze Workaround] DbReq and PDM function as expected, breakpoint redirect
capability compromised.
[Silver Workaround] DbReq, PDM, and breakpoint redirect function as expected,
SCAN capability compromised.
PPIN Opt-in [Auto]
Allows you to enable or disable the PPIN feature.
Configuration options: [Disabled] [Enabled] [Auto]
SNP Memory (RMP Table) Coverage [Auto]
Setting this option to [Enabled] will cover the entire system’s memory.
Configuration options: [Disabled] [Enabled] [Custom] [Auto]
The following item appears only when SNP Memory (RMP Table) Coverage is set to
[Custom].
Amount of Memory to Cover [0]
Allows you to specify MB of System Memory to be covered in Hex.
SMEE [Auto]
Allows you to enable or disable secure memory encryption control.
Configuration options: [Disabled] [Enabled] [Auto]
Action on BIST Failure [Auto]
Allows you to set action to take when a CCD BIST failure is detected.
Configuration options: [Do Nothing] [Down-CCD] [Auto]
Fast Short REP MOVSB [Enabled]
Default set to 1, can be set to zero for analysis purposes as long as OS supports it.
Configuration options: [Disabled] [Enabled]
Enhanced REP MOVSB/STOSB [Enabled]
Default set to 1, can be set to zero for analysis purposes as long as OS supports it.
Configuration options: [Disabled] [Enabled]