User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: BIOS Setup
- 3.1 Managing and updating your BIOS
- 3.2 BIOS setup program
- 3.3 Main menu
- 3.4 Performance Tuning menu
- 3.5 Advanced menu
- 3.5.1 Trusted Computing
- 3.5.2 PSP Firmware Versions
- 3.5.3 Redfish Host Interface Settings
- 3.5.4 AMD CBS
- 3.5.5 APM Configuration
- 3.5.6 Onboard LAN Configuration
- 3.5.7 Serial Port Console Redirection
- 3.5.8 CPU Configuration
- 3.5.9 PCI Subsystem Settings
- 3.5.10 USB Configuration
- 3.5.11 Network Stack Configuration
- 3.5.12 CSM Configuration
- 3.5.13 NVMe Configuration
- 3.5.14 AMD Mem Configuration Status
- 3.5.15 Third-party UEFI driver configurations
- 3.6 Chipset menu
- 3.7 Security menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Event Logs menu
- 3.11 Server Mgmt menu
- 3.12 Exit menu
- Chapter 4: Driver Installation
- Appendix
2-15
ASUS ESC N4A-E11
8. Insert the OCP 3.0 card to the OCP 3.0 slot from the rear of the system (A), and make
sure the OCP 3.0 card is seated securely in the OCP 3.0 slot, then secure it using the
thumbscrew (B).
2.4 Rail Kit Options
This server system supports the rail kit options listed below. For more information on rail kit
installation, refer to corresponding documentation on the ASUS support site or on the official
product site for this server system.
• We strongly recommend that at least two able-bodied persons perform the installation
of the rail kit.
• We recommend the use of an appropriate lifting tool or device, if necessary.
• 2U full extension ball bearing rail kit