User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: BIOS Setup
- 3.1 Managing and updating your BIOS
- 3.2 BIOS setup program
- 3.3 Main menu
- 3.4 Performance Tuning menu
- 3.5 Advanced menu
- 3.5.1 Trusted Computing
- 3.5.2 PSP Firmware Versions
- 3.5.3 Redfish Host Interface Settings
- 3.5.4 AMD CBS
- 3.5.5 APM Configuration
- 3.5.6 Onboard LAN Configuration
- 3.5.7 Serial Port Console Redirection
- 3.5.8 CPU Configuration
- 3.5.9 PCI Subsystem Settings
- 3.5.10 USB Configuration
- 3.5.11 Network Stack Configuration
- 3.5.12 CSM Configuration
- 3.5.13 NVMe Configuration
- 3.5.14 AMD Mem Configuration Status
- 3.5.15 Third-party UEFI driver configurations
- 3.6 Chipset menu
- 3.7 Security menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Event Logs menu
- 3.11 Server Mgmt menu
- 3.12 Exit menu
- Chapter 4: Driver Installation
- Appendix
ASUS ESC N4A-E11
1-7
1.6 Internal features
The server system includes the basic components which may differ between different models,
as shown below:
WARNING
HAZARDOUS MOVING PARTS
KEEP FINGERS AND OTHER BODY PARTS AWAY
A protection film is pre-attached to the front cover before shipping. Please remove the
protection film before turning on the system for proper heat dissipation.
1. Front GPU fans
2. ASUS KMPN-U16
server board
3. System fans
4. Rear GPU fans
5. SATA/SAS/NVMe
backplane
6. 4 x 3.5” storage device
bays
7. PCIe riser card (1
x Gen4 x16 link,
supports OCP 3.0 card
using a OCP 3.0 slot
baseboard)
8. PCIe riser card (2 x
Gen4 x16 link)
9. GPU with air cooling
modules
Air cooling solution