User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: BIOS Setup
- 3.1 Managing and updating your BIOS
- 3.2 BIOS setup program
- 3.3 Main menu
- 3.4 Performance Tuning menu
- 3.5 Advanced menu
- 3.5.1 Trusted Computing
- 3.5.2 PSP Firmware Versions
- 3.5.3 Redfish Host Interface Settings
- 3.5.4 AMD CBS
- 3.5.5 APM Configuration
- 3.5.6 Onboard LAN Configuration
- 3.5.7 Serial Port Console Redirection
- 3.5.8 CPU Configuration
- 3.5.9 PCI Subsystem Settings
- 3.5.10 USB Configuration
- 3.5.11 Network Stack Configuration
- 3.5.12 CSM Configuration
- 3.5.13 NVMe Configuration
- 3.5.14 AMD Mem Configuration Status
- 3.5.15 Third-party UEFI driver configurations
- 3.6 Chipset menu
- 3.7 Security menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Event Logs menu
- 3.11 Server Mgmt menu
- 3.12 Exit menu
- Chapter 4: Driver Installation
- Appendix
3-69
ASUS ESC N4A-E11
Configuration Router Lan1 Address source [Previous State]
Select to configure LAN channel parameters statically or dynamically (by BIOS or by BMC).
Unspecified option will not modify any BMC network parameters during BIOS phase.
The following items are available only when Configuration Router Lan1 Address source
is set to [Static].
IPv6 Router1 IP address
Allows you to change the IPv6 Router1 IP Address.
IPv6 Router1 Prefix Length Lan1
Allows you to change the IPv6 Router Prefix Length.
IPv6 Router1 Prefix Value Lan1
Allows you to change the IPv6 Router Prefix Value.
Shared LAN
IPV6 Support [Enabled]
Allows you to enable or disable LAN1 IPV6 Support.
Configuration options: [Disabled] [Enabled]
The following item appears only when IPV6 Support is set to [Enabled].
Configuration Address source [Previous State]
Allows you to configure LAN channel parameters statistically or dynamically (by BIOS or
BMC). [Previous State] option will not modify any BMC network parameters during BIOS
phase.
Configuration options: [Previous State] [Static] [DynamicBmcDhcp]
Station IPV6 address
Allows you to set the station IPV6 address.
Prefix Length
Allows you to set the prefix length (maximum of Prefix Length is 128).
Configuration Router Lan2 Address source [Previous State]
Select to configure LAN channel parameters statically or dynamically (by BIOS or by BMC).
Unspecified option will not modify any BMC network parameters during BIOS phase.
The following items are available only when Configuration Router Lan2 Address source
is set to [Static].
IPv6 Router1 IP address
Allows you to change the IPv6 Router1 IP Address.
IPv6 Router1 Prefix Length Lan2
Allows you to change the IPv6 Router Prefix Length.