System information

33
July 2006 - InnoMedia
© 2006 InnoMedia. All rights reserved.
InnoMedia Confidential
CONNECTING YOUR WORLDS
Please enter 'y' to configure it or 'q' to exit.
y
Please enter Bandwidth (bps): [128000] 100000
Band Width Entered: 100000 bps
Frames per Packet: 1
Please enter Jitter Buffer Size (0-400(ms), 0 disable
it)[60]: 50
Jitter Buffer Size Entered: 50
Do you want to fix jitter buffer delay? [y/n] n
Do you want to store the changes permanently? [y/n]y
Writing to Flash, please wait...
Writing to Flash is done successfully.
Local Signaling Port (Mk)
The "Mk" command is used to set the local signaling port and the RTP port for the MTA.
The default value for local signaling port is 2427 and the default value for RTP port is
6024. If an RTP port is blocked by an ISP, you can change that value to any even number
between the range of 1024 to 65535.
UMk
The Local signaling port is 2427
The Local voice port start at 6024
which port will be changed(0:signal port;1: voice
port;others: exit)
1
Please input the start voice port
1024
Do you want to save it to Flash? (Y/N)y
Line Parameter Settings (Ml)
Use the "Ml" command to view the various settings for the FXS port(s) on the MTA. As
some MTAs have more than one port, you will need to specify which port settings you
want to view (1-4).
SAMPLE:
UMl
Please input the channel number n/No (0-3)? 0
Channel No =: 0;
active number 0
1.Line Status is: 2;
active number 0
2.Line Codec is: 1;
active number 0
3.Line receiveVoiceGain is: 0;
active number 0