System information

32
July 2006 - InnoMedia
© 2006 InnoMedia. All rights reserved.
InnoMedia Confidential
CONNECTING YOUR WORLDS
Configuring Flash Hook timer (Mf)
Use the "Mf" command to change the default timer for sending a flashhook to the MTA.
The default setting is 900ms, and you may specify it to be as short as 0ms and as long as
1270ms. For most applications, the default setting should be fine.
SAMPLE:
UMf
Flash_Hook_timer = 900 ms, range is [10-1270 ms, this value
depends on your telephone]
Please enter Flash hook timer setting (ms): 800
Do you want to store the changes permanently? [y/n] y
Writing to Flash, please wait...
Writing to Flash is done successfully.
Reboot system to make new setting effective!
Voice Service Control (Mg)
Use “"Mg" to disable or enable the MTA’s ability to make phone calls.
UMg
Current Voice service is enable
Please enter Variant(0:disable;non zero:enable):0
Do you want to store the changes permanently?[y/n] y
INFO: read from NVS_PRIMARY (0x423)
INFO: write to NVS_SECONDARY (0x424)
INFO: write to NVS_PRIMARY (0x424)
flash writing is done.
Jitter Buffer Settings (Mj)
For advanced users, the "Mj" command allows you to change the parameters of the MTA’s
jitter buffer. Jitter buffer size is measured in packets. For example, a value of 2 would
mean 2 packets of jitter. It is recommended not to change these settings from their defaults.
(Default Settings: Bandwidth=12800, Frames per Packet=1, and Jitter Buffer Size=60,
Adaptive.)
SAMPLE:
UMj
Bandwidth (bps) = 128000
Frames per Packet = 1
Jitter Buffer Size (ms) = 60, Adaptive
Do you want to re-configure Jitter buffer size?