System information

30
July 2006 - InnoMedia
© 2006 InnoMedia. All rights reserved.
InnoMedia Confidential
CONNECTING YOUR WORLDS
Configuring Dynamic Payload Type Setting (Md)
The “Md” command allows the user to manually set payload types for supported
codecs. It is recommended that the automatic settings be used. For use with
MetaSwitch call agent, please follow the directions in Appendix B.
UMd
Current Dynamic playload type are
CODEC:G729E, payloadtype:96
CODEC:G726-16, payloadtype:97
CODEC:G726-24, payloadtype:98
CODEC:G726-40, payloadtype:99
CODEC:TELEPHONE-EVENT, payloadtype:100
CODEC:TEL-EVE-BLK, payloadtype:101
Do you want to change the configuration? [y/n]
yinput q for exit
Do you want automatic setting payload type? [y/n]
yDo you want to change the configuration ?[y/n]
y
Flash writing is done.
Do you want to exit? [q/n]
Configuring Control Parameters (Me)
Use the “Me” command to view or change the current control parameters for Provisioning,
DHCP, DHCP Options and Software Upgrade via the provisioning server. The
SW_UPGRADE is in effect only when you have provisioning enabled. Otherwise this
parameter is ignored. Under the “enabled” state, the MTA will always check for a newer
software version as part of the provisioning process. If “disabled” then the MTA will
never check for a new software version.
SAMPLE:
UMe
1. DHCP enable
2. SW_UPGRADE disable
3. PKTC Provisioning, For UNKNOWN; NO SNMP mibs
4. DHCP Check Option 43 disable
5. SNMP mibs
6. MTA does not take DHCP option 12 and 15
7. Currently provisioned maximum waiting delay is 0 seconds
8. HTTP Provisioning Server
9. Disable endpoint bullet packet