System information

Configuring MTA via Telnet/ HyperTerminal Interface
Overview
MTA can also be configured via Telnet or HyperTerminal interface. The following
instructions are for use with a terminal emulation program.
Before You Begin
1. Make sure you have performed the steps outlined in the "
XSetting up Your ComputerX”
section on page X5X.
2. From your PC connected to the "LAN" port on the MTA, run your Telnet Program.
From a windows machine open a Dos Command PromptType in Telnet 192.168.99.1
(or the IP address of your MTA), then press enter.
Configuring MTA via HyperTerminal Interface
To configure your MTA via the Hyper Terminal, follow these steps:
1. Connect the serial cable from your PC to your MTA or IP Phone. Refer to Appendix A
and B for layout.
2. Open the HyperTerminal application on your PC and configure it to the following
settings.
Figure 16. Configuring Your MTA via HyperTerminal-Properties