User Manual

2-1
Chapter 2: DC power board information
Chapter 2
DC power board information
2.1 DC power board layout
INPUT
OUTPUT
DC_OUT
DC_IN
1 2
12V DC-IN jack 4-pin ATX connector
2.2 Installing your DC power board
To install your DC power board:
1. Insert the 12V DC-IN jack on your EMA-DCB-A DC power board into the
hole on the bundled bracket.
2. Place and thread the bundled washer and nut onto the 12V DC-IN jack.
3. Align the holes on the 12V DC-IN jack side of your DC power board and on
the bottom of the bracket, and then secure them with the bundled screws.