manual

All disclosures, notices and warranty conditions are being written on EKWB web page. Please check terms of use. Published on November 21
st
2013
Installing EK-SB ASUS M6G on to the ASUS Maximus VI Hero motherboard.
STEP 1: GENERAL INFORMATION Sample photo of ASUS Maximus VI Hero
STEP 2: PREPARING YOUR MOTHERBOARD
1. REMOVING STOCK COOLER. Remove all encircled screws. There are 4 screws on
the back of the motherboard that needs to be removed in order to remove the factory
installed SB heat sink.
2. CLEANING THE PCB. Carefully detach the original stock cooler after removing all
screws securing it to the board. Wipe off the remains (by using non–abrasive cloth or
q-tip , as shown on sample photo) of the original thermal compound until the
components and circuit board are completely clean. EKWB recommends the use of
denatured alcohol for removing TIM leftovers.
3. APPLYING THERMAL COMPOUND. Apply thermal compound (not included):
lightly coat the Intel Z87 (PCH) with electrically non-conductive thermal grease – for
example Arctic Cooling MX-2 ™, MX-4 ™ or GELID GC-Extreme ™ thermal grease.
EKWB recommends to apply thermal grease in Rice sized dot for best performance (see
sample picture).
STEP 3: PREPARING YOUR WATER BLOCK
STEP 4: ATTACHING BLOCK TO MOTHERBOARD
PLACING STANDOFFS ON THE BLOCK.
Originally the water block comes with
preinstalled 2.5mm standoffs, this
configuration only applies for the ASUS
MAXIMUS VI GENE motherboard.
Brass standoffs are obligatory in order to
attach this water block to the printed circuit
board of the motherboard. Make sure that
the alignment of the 2.5mm standoffs
are like shown on the photo (2, 3).
1.Remove the standoff (encircled below):
2.Mount standoffs to the SB block (encircled
below):
Please use the encased key
3.Placing SB block on the motherboard:
Prior to fastening the screws please make sure the mounting holes on the
motherboard’s circuit board are aligned with the water block.
SB block: Use four (4) M3x4 DIN7985 and four (4) washers. Do not use
excessive force when tightening the screws!
Use the enclosed screws and washers as shown in picture below:
STEP 5: CHECKING FOR CONTACTS
6. POSITIONING FITTINGS AND CONNECTING TO WATER CIRCUIT
Temporarily r emove the water block to
check for uniform surface contact between
the block and the components. Note the
pattern of contact on a piece of paper. Then
repeat steps 3 and 4 to reattach the block
applying more or less pressure to the areas
where you have found it necessary.
Attach the liquid cooling tubes and
connect the water-block(s) into the
cooling circuit. EKWB recommends using
EK-CSQ compression fittings with the EK-
SB ASUS M6G series water block. You can
use any opening as an inlet/outlet port.
Plan your tubing routing in advance!
REQUIRED TOOLS:
philips screwdriver thermal grease
Z87 PCH (SB)
Mosfet
Intel LGA 1150
Chip die thermal grease imprint
EK-CSQ fitting
Tightening
the standoff:
PVC washer
M3x4 screw