User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- 2.1 Chassis cover
- 2.2 Air duct
- 2.3 Central Processing Unit (CPU)
- 2.4 System memory
- 2.5 Storage devices
- 2.5.1 Installing an E1.S module (for E1.S module SKU only)
- 2.5.2 Removing an E1.S module (for E1.S module SKU only)
- 2.5.3 Installing an external 2.5” storage device (on selected models)
- 2.5.4 Removing an external 2.5” storage device (on selected models)
- 2.5.5 Installing an internal 2.5” storage device (only for 650W/Short PSU models)
- 2.5.6 Removing an internal 2.5” storage device (only for 650W/Short PSU models)
- 2.6 Expansion slot
- 2.7 Cable connections
- 2.8 Removable/optional components
- 2.9 Rail Kit Options
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 ACPI Settings
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 Onboard LAN Configuration
- 4.5.5 UEFI Variables Protection
- 4.5.6 Serial Port Console Redirection
- 4.5.7 SIO Configuration
- 4.5.8 PCI Subsystem Settings
- 4.5.9 USB Configuration
- 4.5.10 Network Stack Configuration
- 4.5.11 NVMe Configuration
- 4.5.12 APM Configuration
- 4.5.13 Tls Auth Configuration
- 4.5.14 Intel(R) Virtual RAID on CPU
- 4.5.15 Third-party UEFI driver configurations
- 4.6 Platform Configuration menu
- 4.7 Socket Configuration menu
- 4.8 Security menu
- 4.9 Boot menu
- 4.10 Tool menu
- 4.11 Event Logs menu
- 4.12 Server Mgmt menu
- 4.13 Exit menu
- Appendix
4-32
Limit CPU PA to 46 bits [Enable]
Allows you to limit CPU physical address to 46 bits to support older Hyper-v. If
enabled, automatically disables TME-MT.
Configuration options: [Disable] [Enable]
Clock Modulation Enabled [Auto]
When
[Auto] is set, the setting will be based on Si Compatibility.
Configuration options: [Disable] [Enable] [Auto]
Uncore Per Socket Configuration
CPU1
CPU 1 UPI Port 3
The options in this submenu allow you to configure CPU 1 UPI Port 3
configurations.
4.7.4 Memory Configuration
Enforce DDR Memory Frequency POR [POR]
Allows you to enforce Plan Of Record restrictions for DDR frequency programming.
Configuration options: [POR] [Disable]
Enforce Population POR [Enable]
Allows you to enable or disable memory population POR enforcement.
Configuration options: [Disable] [Enable]
Memory Frequency [Auto]
Allows you to select the maximum memory frequency setting in MT/s. If Enforce POR is set
to [Disable], user will be able to run at higher frequencies than the memory support (limited
by processor support). Do not select Reserved.
Configuration options: [Auto] [3200] [3600] [4000] [4400] [4800]