E4992 Windows® 7 Edition Quick Use Guide 15G06Q179000
Powering on your Eee PC These are only quick instructions for using your Eee PC. 1. Install the battery pack 2. Connect the AC power adapter 3 1 2 2 1 3. 3 110 V-220V Turn ON the Eee PC Damage may occur if you use a different adapter to power the Eee PC. You may damage both your battery pack and the Eee PC with a faulty AC-DC adapter.
Shutdown Do the following instructions to turn down your Eee PC. 1. 2. Click the start button to display the start menu. Click Shut down to power off your Eee PC.
Launching for the First Time For the first time you start your Eee PC, the Windows wizard will launch automatically and lead you through setting up your preferences and some basic information. Follow the wizard instructions to finish the initialization. Configuring a network connection Wireless Network Connection 1. Click the wireless network icon with an orange star Windows® Notification area.
Local Area Network To establish a wired network, follow the instructions below: Using a dynamic IP / PPPoE network connection: 1. Click the network icon with a yellow warning triangle in the Windows® Notification area and select Open Network and Sharing Center. 2. Click Change adapter settings in the left blue pane. 3. Right-click Local Area Connection and select Properties.
4. Click Internet Protocol Version 4(TCP/IPv4) and click Properties. 5. Click Obtain an IP address automatically and click OK. (Continue the following steps if using PPPoE) 6. Return to the Network and Sharing Center and then click Set up a new connection or network.
. Select Connect to the Internet and click Next. 8. Select Broadband (PPPoE) and click Next. 9. Enter your User name and, Password, and Connection name. Click Connect. 10. Click Close to finish the configuration. 11. Click the network icon in the taskbar and click the connection you just created. 12. Enter your user name and password. Click Connect to connect to the Internet.
Using a static IP: 1. 2 3. 4. 5. Repeat the step 1–4 of Using a dynamic IP / PPPoE network connection to start the static IP network configuration. Click Use the following IP address. Enter the IP address, Subnet mask and Gateway from your service provider. If needed, enter the preferred DNS Server address and alternative address. After entering all the related values, click OK to build the network connection. Contact your Internet Service Provider (ISP) if you have problems connecting to the network.
