User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5-inch storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an M.2 B-key module
- 3.9 Installing antennas (optional)
- 3.10 Installing wall mount brackets (optional)
- 3.11 Installing the VESA mount (optional)
- Chapter 4: Watchdog Timer
- Appendix
72
3.11 Installing the VESA mount
(optional)
1. Place your Embedded Computer upside down on a at and stable
surface.
2. Attach the bundled two (2) 12mm screws into the screw holes at the
bottom of your Embedded Computer.
3. Remove the screw hole covers at the back of your VESA mount-
compatible device, if they exist.
You may install a VESA mount to your Embedded Computer, which allows
you to install your Embedded Computer to a VESA mount-compatible
device, such as a monitor.
IMPORTANT! When installing your Embedded Computer to a VESA
mount-compatible device, such as a monitor, ensure to rst consider
the stability of the setup. This is especially critical for VESA mount-
compatible devices that weigh less than 4.97 kg.