User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5-inch storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an M.2 B-key module
- 3.9 Installing antennas (optional)
- 3.10 Installing wall mount brackets (optional)
- 3.11 Installing the VESA mount (optional)
- Chapter 4: Watchdog Timer
- Appendix
68
To install an antenna:
NOTE: If your Embedded Computer came pre-installed with wireless
card antenna jacks, skip to step 8.
1. Remove the bottom cover. Refer to Removing the bottom cover for
details.
2. Prepare the RF connector and cable.
3. Remove the rubber caps from the antenna holes.
4. Insert the antenna jack end of the RF connector and cable into the
antenna hole from within the chassis outwards, ensuring that the at
edge of the jack is properly aligned to the at edge of the hole.
5. Insert the bundled O-ring over the antenna jack.
6. Secure the antenna jack using one of the bundled hex screws.
7. Connect the other end of the RF connector and cable to your wireless
card (refer to Installing a wireless card to the M.2 (E-key) slot for
details) or to your 4G LTE / 5G NR module (refer to Installing an M.2
B-key module for details).
8. Replace the bottom cover. Refer to Replacing the bottom cover for
details.
9. Screw the external Wi-Fi antennas onto their corresponding antenna
jacks on the front and rear panels by turning them in a clockwise
direction.
10. Position the antennas for optimal signal reception.